![]() I thought that the point of a forum was to discuss ideas and options. And quite frankly it is easier to learn than Fusion360 although I working my way through the tutorials on that too. This option and plugin with CamBam seems to offer an all in one software option. ![]() What I dont like about most setups is the requirement to create a cad file in one program, transfer it to another to create the cam file and then send it with yet another to the machine. (14.0 MB) Ubuntu 16 based Linux / Mint 18. ![]() Considering that the total cost for an arduino, ramps board and 5 Drv8825 drivers is under $35, how can you compete? Just the single motor drivers on my last router were twice that each. License emails should not take longer than 24 hours and are usually sent within a couple of hours of the order being placed. Please let me know if these havent arrived. I have resent the license email from a couple of different mail accounts. It opens up a lot of options for low cost controllers. I am very sorry you didnt receive your license key. I am embracing the arduino as a parser for gcode. It works great once you figure out the Linux part. I have always used LinuxCNC as my controller on an old parallel port tower machine. I have built 4 CNC routers from scratch to date. I was simply trying to share an option I found. There is a very long running thread about estlcam with Ramps support. I am quite familiar with the differences between firmware and software and what software does what.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |